How to: RGB Corners

The below guide shows how to create corners with an RGB or CCT LED Strip using a LEDSpace connector pack.

You'll need:

• FIRST test your LED Strip, before moving on to the next step

• Measure and cut your LED Strip on the designated cutting point

  

• Cut a short length of cable from the pack. Don't strip the insulation from the cable as the barbs are designed to pierce it.

  
  IMPORTANT!

  Do not strip the insulation from the cable!

• Slide connectors onto either end of the cable, taking note of the colour order of the LED Strip

  

• Slide the LED strips into the other sides of the connectors, ensuring that it sits all the way in and the polarity is the same.

  

• Push the barbs down into the cable and LED side of the connector

  
  Pro Tip!

  We recommend pushing down against a solid surface to avoid bending the barbs.

• Holding the connectors, bend the cables around to form the corner

  
• Test each corner as you go to make sure you have not damaged the LED Strip or caused a short circuit