Using Blaq Aura with the HALO Smart system (Zigbee)

Using BLAQ Aura with a Zigbee Control System (HALO Smart)

Most of the components in the system will remain the same - it is only the in-line controller that differs.

Set up your transformer as normal - mains power in, 24vdc out.

Connect the output from the transformer to the input of the zigbee controller.

For each of your BLAQ Aura LED strips, connect the reciprocal barrell jack connector, using a separate 'channel' on the zigbee controller for each strip. All of the positives can be connected together. Connect the LED Strips to these connectors.

Power up the system - Don't worry if not all strips illuminate at this point.

Hold down the Match/Set button on the interface, until the indicator LED turns a solid white. Let go once it does.

Go to your Hub's app, and add the controller as a new device.

You can then pair your remote, if you purchased one, by following the below instructions:
Ensure the battery is in the remote control & the plastic seperator has been rmeoved.

You can click the power button on the remote control to check that the indicator light in the top right lights up.

Press and release the match button on the controller - the LED Strips should flash.

Press the power button on the remote control a couple of times, within five seconds of the first LED Flash.

Your remote should now be paired.